Skip to main content
RACELOGIC Support Centre

Recording/Replaying RS232 With LabSat 3

Recording

  1. Connect the ‘RS_Rx’ and ‘GRN’ ports of the expansion connector to the appropriate wires/cable.
  2. Power up the LabSat 3 and navigate to the ‘Digital’ section of the menu. Select the ‘RS232’ option.
  3. Fit the expansion connector to the LabSat.
  4. Pressing the ‘REC’ button on the front of the LabSat will begin the recording. The LabSat will record all serial messages available.
     

Recording RS232-2.png

 

Replaying

  1. Connect to the ‘RS_Tx’ and ‘GRN’ ports on the LabSat 3 expansion connector.
  2. Press the ‘Play’ button on the front of the LabSat to start the scenario replay.
     

Replaying RS232.png
 

If you need any further information about using the LabSat 3 for recording and replaying RS232 data, please get in contact with the Racelogic Support Department.

  • Was this article helpful?