Skip to main content
RACELOGIC Support Centre

Recording/Replaying Arbitrated CAN With LabSat 3 Wideband

Recording

  1. Connect the 'CAN1 High' and 'CAN1 Low' ports of the expansion connector to the appropriate wires/cable.
  2. Connect the LabSat 3 Wideband antenna (RLACS249) to the 'RF IN' port.
  3. Power up the LabSat 3 Wideband and navigate to the ‘CAN’ section of the menu. Ensure the ‘Log file’ option is selected and set the baud rate for both CAN channels.
  4. Fit the expansion connector to the LabSat.
  5. Pressing the ‘REC’ button on the front of the LabSat will begin the recording. The LabSat will record all CAN data available on the connected Bus.
     

recording_can (1).png

Replaying

  1. Connect the 'CAN1 High' and 'CAN1 Low' ports of the expansion connector to the appropriate wires/cable.
  2. Connect the device under test to the LabSat 3 Wideband 'RF OUT' port.
  3. Fit the expansion connector to the LabSat.
  4. Power up the LabSat 3 Wideband and navigate to the ‘CAN’ section of the menu. Ensure the ‘Replay Log file’ option is selected.
  5. Highlight the scenario, pressing the 'Play' button on the front of the LabSat will begin the replay. The LabSat will replay all CAN data originally recorded.
     

replaying-can.png
 

If you need any further information about using the LabSat 3 Wideband for recording and replaying Arbitrated CAN data, please get in contact with the Racelogic Support Department.

  • Was this article helpful?