Skip to main content
RACELOGIC Support Centre

06 - Brake Test SW Test setup

Configuration of the setup criteria can be done using the Test Set-Up option, found under the settings toolbar. 
 

setup1 (1).png

Adjust Units 

The units for speed, distance and acceleration can all be changed.  These changes are reflected in all other windows in the software.
 

setup2 (1).png

 

Hardware Trigger

Configure a minimum speed for the hardware trigger to prevent unwanted trigger activation from being used in the results generation.  Also configure whether the reported trigger speed is from the first measured sample after trigger activation, or a speed value interpolated between the reported and previous sample. 
 

setup3 (1).png

End Speed

Determine the speed that the brake test finishes and results are reported from.


setup4 (1).png

Corrected Distance

Determine the ‘corrected distance start speed’, either by a specific value or an auto corrected value to the nearest 10km/h (or mph).  


setup5 (1).png

 

Smoothing

Some input channels can be inherently noisy so require a certain level of smoothing to create representative results.  Use option to apply desired levels of smoothing to speed, acceleration and all CAN channels in this option.
 

setup6 (1).png

Software Trigger

Configure a starting speed for the software to create separate braking distances from. 

This should be utilised when a hardware trigger is not available. 
 

setup8 (1).png

MFDD

Adjust the speed values used in the MFDD calculations. Also chose between actual speeds or percentage of trigger/start speed.
 

setup9 (1).png

Centreline Deviation

Adjust settings for centre line deviation computation.

Full period duration - Time before trigger activation, this is what is used to calculate the centre line reference heading.

Full Period std. dev. max – The maximum allowed heading deviation during test.

Average Heading Tolerance – The allowable tolerance of heading change during centre line deviation.

Std. dev. Warning threshold – Heading deviation threshold before results displayed with red warning text.
 

setup10 (1).png
 

Note: Centreline Deviation results in Red:
 

setup11 (1).png

  • Was this article helpful?