04 - LabSat3 Menu layout

File

• Info - Display file info for selected file.
• Delete – Delete selected file Yes/No.
• Format SD/USB – Erase and Format SD/USB Yes/No.
   

Constellation

• GPS/GAL – Tick to select GPS/Galileo constellation for recording.
• GLONASS – Tick to select GLONASS constellation for recording.
• BeiDou – Tick to select BeiDou constellation for recording.
• 2Bit – Record with 2 bit quantisation when single constellation is selected.
   

Play

• Loop – selected file will replay continuously.
  • Pause Time – Defines the pause time between each replay.
• From – Specify a time in the scenario to replay from.
• For - Specify how long the scenario will replay for.
   

Record*

• For - Specify how long the LabSat 3 will record for.
   

Setup

• Display – Adjust display contrast and backlight brightness.
• RF Test – Outputs RF test signal.
• Power Save – When selected, will power down display backlight and internal monitor during recording.
• CLK REF
  • Internal - As the default setting LabSat 3 will use it internal reference clock.
  • External 10MHz – Allows the user to connect a 10 MHz reference signal on the REF input.
• Time – Configure internal clock using UTC time from internal GNSS monitor or set manually.
• LAN
  • DHCP – Enable/Disable DHCP.
  • IP Address – Set the IP address assigned to LabSat 3.
  • SUBNET MASK - Set the Subnet mask assigned to LabSat 3.
  • DEFAULT GATEWAY - Set the default gateway for the network.
• Digital*
  • CH1
    • 1PPS – Record 1PPS signal from internal GNSS monitor (disable power save).
    • RS232 – Record RS232 signal.
    • CAN CH1 – Record CAN Bus channel 1.
    • DIGI – Record state of DIGI input signal.
  • CH2
    • 1PPS – Record 1PPS signal from internal GNSS monitor (disable power save).
    • RS232 – Record RS232 signal.
    • CAN CH2 – Record CAN Bus channel 2.
    • DIGI – Record state of DIGI input signal.
• CAN*
  • Record Type
    • Digitize – When selected the CAN data will be digitized and integrated into the .LS3 file.
    • Log File – When selected the CAN data will be logged into a separate .txt file.
      • CH1
        • Baud rate – Enables the user the set the desired baud rate.
        • Silent Record - Determines whether or not the LabSat sends an acknowledge pulse during recording.
      • CH2
        • Baud rate – Enables the user the set the desired baud rate.
        • Silent Record – Determines whether or not the LabSat sends an acknowledge pulse during recording.
           

About – Contains information specific to the LabSat e.g. serial number & firmware version.
 

Exit – Return to file list.

*These are not included as standard in single constellation LabSat 3 units.