Skip to main content
RACELOGIC Support Centre

VBOX Configuration - Static Point (NTRIP)

To configure the VBOX within a Vehicle when using a target point as the static reference point, using an NTRIP correction solution for AEB or FCW tests, please follow the steps below:

  1. Connect VBOX Manager to the VBOX in the Vehicle.
     
  2. Enter the 'SETUP' menu of VBOX Manager.
     
  3. Select the 'VBOX' option and scroll to 'Log Rate'. Ensure that '100 Hz' is selected, if it is not, select the menu and choose the option.
 VBMAN ADAS Subject Contact Points.png  VBMAN ADAS Subject Contact Points.png
  1. Scroll to 'Dynamic Mode', select and then choose one of the following options:
    • If you are not using IMU integration, set the dynamic mode to 'Medium' and press to confirm, this Dynamics mode is best for ADAS tests.

      VBMAN ADAS Subject Contact Points.png
       
    • If you are using IMU integration, set the dynamic mode to 'High' and press to confirm.

      VBMAN ADAS Subject Contact Points.png
       
  2. Scroll to 'DGPS Rate' and ensure that '115200' is selected, if it is not, select the menu and choose the option.

    VBMAN ADAS Subject Contact Points.png
     
  3. Scroll to 'DGPS Mode', select and then set to 'NTRIP', press to confirm. Further information on NTRIP can be found here.

    VBMAN ADAS Subject Contact Points.png
     
  4. Return to the 'SETUP' menu by selecting 'Back'.

    VBMAN ADAS Subject Contact Points.png
     
  5. Select the 'ADAS' option and then choose 'Static Point' as the ADAS mode, press to confirm.
 VBMAN ADAS Subject Contact Points.png  VBMAN ADAS Subject Contact Points.png
  • Was this article helpful?