LED Behaviour - MFD Touch

The 4 LEDs at the top of the unit provide visual feedback dependent on what process is being performed. Multiple alerts can occur. The colour of the LED will indicate the event: 

Blue is an alert at speed 
Red is a parameter alert
Green is a configured test alert
 

• On the Parameter screens
  • If you have set the Target Speed LED Alert, the LEDs will flash blue when it reaches the value.
  • If you have set the Parameter LED Alert, the LEDs will flash or appear solid red when the alert condition is met.
  • If you have enabled Alert at Start, the LEDs will flash green when the decel test start speed criteria are met.
  • If you have enabled Alert at Trigger, the LEDs will flash green when the decel test trigger test has started.
  • If you have enabled Alert at End, the LEDs will flash green when the decel test start speed criteria are met.
     
• In the Parameter Settings menu:
  • If you have enabled Parameter LED Alert, the LEDs will preview the settings in red.
     
• In the General Settings menu:
  • If you Save the Settings to an inserted SD card, the LEDs will flash green. If a settings file with the same name already exists on the SD card and you cancel the overwriting, the LEDs will briefly flash red.
  • If you Load Settings from an inserted SD card, the LEDs will flash green.
  • If you Reset the Session Data, the LEDs will flash green. If you cancel the reset, the LEDs will briefly flash red.
  • If you have set a Target Speed LED Alert, the LEDs will flash blue. 
     
• In the Test Settings menus:
  • If you have enabled Alert at Start, the LEDs will flash green.
  • If you have enabled Alert at Trigger, the LEDs will flash green.
  • If you have enabled Alert at End, the LEDs will flash green.
  • If you try to enable Write Results File when the unit cannot detect an SD card, the LEDs will flash red.