Skip to main content
RACELOGIC Support Centre

03 - DAC01 Analogue outputs calibration

To re-calibrate the four analogue outputs, select this option. Please note a voltmeter will be needed to complete this procedure. 
 

calibrate (1).png
 

 

The DAC01 will first output a low voltage on each channel, measure the voltage and enter the individual values.
 

calibrate2 (2).png
 

In the next step, the DAC01 will output higher voltages. Again, these needs to be measured and the values entered. 
 

calibrate3 (1).png
 

 

The DAC01 will then output 5 V on each channel. This is the end of the calibration procedure. 
 

calibrate4 (1).png
 

If an official certificate of conformity is required, please contact support@racelogic.co.uk or your local dealer.

  • Was this article helpful?