Skip to main content
RACELOGIC Support Centre

03 - TC8 Installation


To connect the module to a VBOX, use the 5 way LEMO to 5 way LEMO cable Plug one end of this cable into the CAN port on the VBOX; plug the other end of the cable into either connector 1 or connector 2 of the TC8. The function of connectors 1 & 2 on the thermocouple module is the same to allow daisy chain connection of other devices on to the CAN bus. Power is also supplied to the module through the CAN Bus cable. The example below shows a typical brake test setup.

TC8 Setup.png

  • Was this article helpful?