Pinouts - VBOX Touch (v2/v3)
Right-side view of VBOX Touch
Connector 1 - GNSS Antenna
| PIN | I/O | Function |
|---|---|---|
| Centre | I | RF Signal/Power for active antenna |
| Chassis | I | Ground |
Connector 2 - D IN (3-pin Lemo)
Digital Input Connector that can be used for logging switch or event and brake triggers.
| PIN | I/O | Function |
|---|---|---|
| 1 | I | Ground |
| 2 | I | Digital Input 2 - Logging ON/OFF |
| 3 | I | Digital Input 1 - Event/Brake Trigger |
Connector 3 - CAN/SERIAL (5-pin Lemo)
Isolated CAN bus with active 120 ohm terminating resistors
| PIN | I/O | Function |
|---|---|---|
| 1 | O | RS232 Tx |
| 2 | I | RS232 Rx |
| 3 | I/O | CAN High |
| 4 | I/O | CAN Low |
| 5 | I | Power |
| Chassis | I | Ground |
Connector 4 - CAN/SERIAL (5-pin Lemo)
Isolated CAN bus with active 120 ohm terminating resistors
| PIN | I/O | Function |
|---|---|---|
| 1 | O | RS232 Tx |
| 2 | I | RS232 Rx |
| 3 | I/O | CAN High |
| 4 | I/O | CAN Low |
| 5 | I | Power |
| Chassis | I | Ground |
Connector 5 - POWER (2-pin Lemo)
| PIN | I/O | Function |
|---|---|---|
| 1 | I | Power |
| 2 | I | Ground |
| Chassis | I | Ground |