Skip to main content
RACELOGIC Support Centre

03 - TTMS Hardware Installation

Install the infrared temperature sensors and wiring loom on to your vehicle, making sure the sensors are positioned directly opposite and central to each tyre surface.

Two 3.2 mm holes are available on either side of each sensor for securely mounting them to the chassis. Alternatively, 3M Dual Lock can be used, however it is advisable to tether them to the chassis as well.

TTMS Hardware Install.png


4 temperature sensors.jpg

Be aware of the order in which the 16 infrared beams are arranged when mounting the sensors, shown in the image below (note the orientation of the sensor in the diagram). This is important when selecting the Orientation and Direction of the sensors within the Sensor Settings menu.


You must ensure that the infrared beams cover appropriate spots across the tyre surface. Both shoulders of the tyre and 2 additional spots in between should be included to ensure full coverage, as shown by the green dots in the image below.

After the installation is complete, ensure to plug the Lemo connector from the infrared Tyre Temperature Monitoring loom in to a 'CAN / SERIAL' socket on the side of the VBOX Touch display.

  • Was this article helpful?