Performance Box Touch V2 – Speed Display Mode

Speed Display - Speed Screen

This is the default speed screen and it displays Live Speed data. If you have set a Target Speed in the Speed Settings, this will be displayed in grey underneath the Live Speed.

If the vehicle speed is slower than 0.5 km/h or if the unit has lost its satellite lock (less than 4 satellites), the value will display as 000.0.

Speed Display - VMAX Screen

This screen displays the Absolute Top Speed reached until the Reset Button is pressed at the bottom of the screen.

If a Target Speed is selected within the Speed Settings, it will be displayed in grey underneath the VMAX.

Speed Display - Average Speed Screen

Formatted in two halves, the Average Speed screen displays both the Average Speed (since last boot-up or power cycle) and Distance Travelled (since last boot-up or power cycle) on the same screen any time that movement is detected. The average speed is displayed using either continuous or moving calculations.

You can reset the screen at any time by pressing the Reset Button at the bottom of the screen.

If you have selected a Target Speed in the Speed Settings, it will be displayed in grey underneath the Average Speed.

Decimal Places

You can adjust the number of decimal places displayed for speed values across all Speed displays. Choose between 0, 1 (default) and 2 decimal places. Tap the corresponding blue button to cycle through the options.

Speed Display Smoothing

If required, you can choose to have the displayed live speed values smoothed. Available options include 0.0 s, 0.25 s (default), 0.5 s and 1.0 s and they refer to the amount of time that the displayed data is averaged by. Tap the corresponding blue button to change the smoothing levels.

IMPORTANT
This option will smooth live speed displays in all relevant screen modes.
 

Notes:

• Smoothing only applies to the screen displays, not to the recorded data.
• Smoothing introduces a slight delay to the displayed value.

V Avg Mode

You can change whether the average speed on the Average Speed Screen is calculated as Continuous or Moving.
 

• Continuous: Average speed will start to calculate as soon as an SD card is inserted and initialised.
• Moving: Average speed will start to calculate as soon as the unit detects a speed of more than 0.8 km/h. The calculations will stop when the speed is less than 0.8 km/h.

Distance Display 

This setting lets you change the unit used for the distance travelled when you are using the Average/Distance screen. The Distance Display setting will toggle between Feet/Miles (if the Distance unit is set to feet in the General Settings) or will toggle between Metres/Kilometres (if the Distance unit is set to metres in the General Settings).

Set a Target Speed

You can define a Target Speed that will be displayed underneath the Speed value on the Speed Screen, VMAX and Average Speed Screen.

You can choose whether to enable or disable an audible alert (continuous beep for 2 seconds) along with a visual alert (all 4 LEDs flashing green) to notify you when the target value is reached. Alerts will only show once unless the vehicle has been stationary since the previous alert.

Enabling one, or both, of the alerts will set the target speed and give you access to the sub-menu where you can define the target speed condition by pressing the corresponding blue button and using the presented keypad.
 

Target Speed Keypad Example

To save your chosen value, press the Confirm button at the bottom right of the screen. Press the Cancel button at the bottom left of the screen to return to the Settings screen without saving. The unit will remember the value after each power cycle.

Note: You can enter speed with up to 1 decimal place.