Skip to main content
RACELOGIC Support Centre

04 - MFD Touch Data Display

Adding/Removing Screens

MFD Touch can display up to 6 defined VBOX 3i parameters. 8 different screens are available, displaying a varying amount of parameters and gauges. A maximum of 10 screens can be added.

When the unit is booted up for the first time, the "6 Numerical" screen will be presented by default. If you would like to add more screens, press the Forward Forward Arrow.png or Back VBOX Touch Back Button.png buttons on the bottom right of the screen, or swipe left or right on the screen to access the ADD/REMOVE screen. It is always available before the first display screen and after the last display screen.
 

MFD Touch_Add Remove Screen (Both Buttons Active).png
 

Add a new screen by selecting the Add Screen button. This will open up the ADD page selection screen where you can choose which display you would like to add. Swipe left or right on the screen or use the Forward or Back arrows on the sides of the screen to navigate through the available screens: 1 NUMERICAL, 3 NUMERICAL, 4 NUMERICAL, 6 NUMERICAL, ANALOGUE GAUGE, G-BALL, TARGET or BAR GRAPH.
 

MFD Touch Add.png

 

To add the screen, press the Confirm button Confirm Button.png on the bottom right of the screen to display the added screen. 

If you press the Cancel button Cancel Button.png on the bottom left of the screen you will return to the ADD/REMOVE screen without saving. 

MFD Touch_Remove G-Ball.png
 

To remove a screen, press the Remove Screen button from the ADD/REMOVE screen, select the screen by swiping left or right or by using the Forward or Back arrows on the sides of the screen. Press the Confirm button Confirm Button.png on the bottom right of the screen.


Note: It is NOT possible to configure screens on an MFD Touch unit by using the VBOX Setup Software.

Display Screens

Once you have added screens, you can change the display by selecting the Forward Forward Arrow.png or Back Backwards arrow.png arrows on the bottom right of the screen or by swiping left or right. You can find more information about the different screens by clicking on the images below.

MFD Touch_1 Numerical (780x505).png
1 Numerical Screen
MFD Touch_3 Numerical (780x505).png
3 Numerical Screen
MFD Touch_4 Numerical (780x505).png
4 Numerical Screen
MFD Touch_6 Numerical (780x505).png
6 Numerical Screen
MFD Touch_Analogue Screen with Data Screen Index (780x505).png
Analogue Gauge Screen
MFD Touch_G-Ball (780x505).png
G-Ball Screen
MFD Touch_Target Graph (780x505).png
Target Screen
MFD Touch_Bar Graph (780x505).png
Bar Graph Screen
 
 

Change Screen Name

You can change the name of each parameter screen by either pressing and holding or double-tapping the existing screen name at the top of the display. Enter the new screens name by using the presented keypad.

MFD Touch Screen Name Change.png
Existing Screen Name
MFD Touch Screen Name Change Keypad.png
Screen Name Keypad Example

To save the new name, press the Confirm button Confirm Button.png on the bottom right of the screen. Press the Cancel button Cancel Button.png on the bottom left of the screen to return to the parameter screen without saving. If you have an SD card inserted in the unit, it will remember the value after each power cycle.

 

Configure a Parameter

You can configure each parameter by either pressing and holding or double-tapping the existing parameter area. This will open up the screen-specific menus.
 

MFD Touch Parameter Change.png

  • Was this article helpful?