02 Hardware Overview - VBOX Video HD2 (v1-5)

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

For a quick step by step guide of setting up the VBOX Video HD2 system in a vehicle, click here to see the Quick Start Guide.

Hot surface1.jpg

The VBOX Video HD2 is designed to disperse heat from internal components through the lid of the box, as such the unit will become hot to the touch when running.

The enclosure is designed to use airflow to cool the unit down, so do ensure that the top of the HD2 is left open to the air.

If VBOX Video HD2 is being used in extreme ambient temperatures (cabin temperature exceeding 50°C), the Harsh Environment Fan Accessory can be used to reduce the temperature of the unit.

IMPORTANT

If the HD2 is being used in conjunction with a driver communication radio system, ensure that there is a minimum separation distance of 20 cm between the radio system and the camera units and cables to avoid any video interference problems.

Inputs/ Outputs

Inputs

2 x Camera Inputs (CAM 1/CAM 2)
Resolution: 1920 x 1080p or 1280 x 720p at 30 or 60 frames/second (see the Camera specs for your camera to see the relevant specifications)
FOV: 148° horizontal, 86° vertical, 163° diagonal
2 x Audio Inputs (MIC)
Stereo audio recording with automatic gain control and line level input option
Bluetooth
For start/stop logging switch, heart rate monitor or OBD dongle
RS232 (CAN/SER)
For communication with OLED Display
CAN Bus (CAN/SER)
Allows user to log up to 80 CAN signals

Outputs

SD Card
Fast 32 GB card supplied with device Fast SD card required – tested up to 512 GB supported
USB 2.0 Host Interface (USB)
For recording to USB flash drives, fast USB drive required
WiFi
For camera setup/preview
RS232 (CAN/SER)
For communication with OLED Display

LED Behaviour

If two solid green LEDs are shown, the system is ready to record.

If the system is permanently fitted to a vehicle, it should be possible to view the front panel when it is mounted. A brief overview of the LED behaviour is below.

OK LED
Green – Fast Flash	System powering up or updating firmware/ scene
Green – Slow Flash	Fully powered - No SD Card/ USB Memory
Green – Solid	SD Card/ USB Memory OK – READY TO LOG
Orange – Slow Flash	Requires reboot
Red – Solid	System Error The unit will automatically power cycle after approximately 30 seconds

GPS LED
Green – Slow Flash	Searching for Satellites
Green – Solid	GPS Lock OK – READY TO LOG

REC LED
Blue – Solid	Recording – DO NOT REMOVE MEDIA
Blue – Fast Flash	Closing Files – DO NOT REMOVE MEDIA

There is a fourth LED on the rear of the system. If the mounting solution only allows the back panel to be visible, this status LED works on a simple ‘traffic light’ style system.

Status LED
Red	System Error
Orange	Not ready to record (either no GPS or no SD Card USB Memory)
Green	Ready to record – system all OK
Blue	Recording – DO NOT REMOVE MEDIA

Connection Diagrams

Information on connecting different types of OLED displays is available here.

Note: Not all new cameras will be compatible with all HD2 hardware versions. See the camera compatibility table to confirm the camera compatibility for your HD2 unit.