Skip to main content
RACELOGIC Support Centre

03 Front Panel


To facilitate unit configuration, the VBOX Speed Sensor has an OLED display and four membrane buttons on the front panel.

Alternatively, you can use VBOX Setup to configure the VBOX unit.

VBOX 3iSDR - Front Display_600px.png
VB3iS Display Up Arrow.png Menu up / Increase the value when editing a number. VB3iS Display Back.png Move to the previous menu level.
VB3iS Display Down Arrow.png Menu down / Decrease the value when editing a number.

VB3iS Display OK.png

Enter the menu / select menu item for adjustment.
When the VBOX Speed Sensor is powered up, it will display the RACELOGIC logo along with hardware variant and the serial number of the unit. Next, it will change to display the firmware version of the unit. VBSS100-V5 Startup - Splash screen.png

When the unit has initialised and any warnings have been cleared, the number of satellites will be displayed.

VBSS100-V5 Startup - Satellite count.png

Press the Down arrow to open the status screen where you can view information about Speed, Satellite count, RTK Status and Wheel Speed.  

Press the Up arrow to return to the main screen.

Note: Wheel speed is not supported on the VBOX 100 Hz Speed Sensor (v5).

VBSS100-V5 - Startup screen.png

Settings Menu
You can access the menu by pressing the OK button. Use the Up and Down arrows to navigate through the menu and press the OK button to enter a submenu. 



Factory Reset
You can reset the unit to its factory settings by pressing the Up and Down arrow buttons simultaneously and holding them for 5 seconds. After this period, the unit will beep and it will play an audible confirmation signal when the reset is finished.
VB3iSDR reboot.png
Note: Receiver settings (Dynamic Mode, DGNSS Mode, DGNSS Rate and Elevation mask) will not reset.
  • Was this article helpful?