1. Download the latest firmware file from the Racelogic website and copy this file onto your PC.
2. If you have done a full VBSS CD installation then you will have the upgrade program automatically installed in the Utilities folder of VBSS folder. If not, then this can be downloaded from the software section of the VBOX website.
3. Connect your  VBSS to your PC via a RS232 connection lead and apply power to the VBSS.
4. Either ‘double click’ on the ‘.ruf’ upgrade file, which auto runs the Upgrader software, or run the Upgrader software and load in the ‘.ruf’ firmware upgrade file. Then follow the onscreen instructions and the VBSS firmware will be upgraded.
5. At the end of the process, power down the VBSS when prompted.
6. During the upgrade process an upgrade log file will have been created. This log file can be emailed to the support address below should any problems arise.

New Features and Functionality

• Disabled individual satellite constellation information; as a result, output latency is fixed at 40 ms.

Bug Fixes

• Fixed an issue that caused spikes in the Digital Output.

• Support for new 100 Hz hardware variant, V5.

• Improvements in positional CAN data - MFD and CAN output match

• Added support for VBSS100SLR (RTK enabled speed sensor)

• Enabled CAN delay changed to 20ms
• Increased number of CAN channels available when in Enabled CAN delay

• Improved CAN delay function VBSS100

• Implemented compatibility with Racelogic Config for all VBSS 05-100 units

• Added speed clamp function
• CAN delay function added for VW
• Bug fixes

• Support for new GPS engine revision

• Trigger output added to serial stream for use with Brake Test Software

• ADAS support added.

• Feature: Lean angle added
• Bug fix: Scaling of 307 CAN message corrected
• Bug fix: Non-consecutive CAN ID transmission fixed
• Bug fix: Improvement made to calculation of radius of turn

First release